Hitachi VSPG REST API support
REST API replaces Hitachi CCI (raidcom commands) and SNMP protocol.
Therefore you no longer have to install CCI to STOR2RRD appliance.
Refere to
install manuall how to configure it.
Supported storage systems
The REST API supports the following storage systems.
| Storage system | Supported firmware version |
|---|
| VSP Gx00 models | For VSP G350, G370, G700, G900 88-01-0X-XX/XX or later
For VSP G200, G400, G600, G800 83-01-21-XX/XX or later |
| VSP G1000 | 80-01-21-XX/XX or later |
| VSP G1500 | 80-05-XX-XX/XX or later |
| VSP Fx00 models | For VSP F350, F370, F700, F900 88-01-0X-XX/XX or later
For VSP F400, F600, F800 83-02-01-XX/XX or later |
| VSP F1500 | 80-05-XX-XX/XX or later |
| VSP N400, N600, N800 (1) | 83-06-03-XX/XX or later |
| VSP E590, E790, E990 | 93-01-0X or later |
| Virtual Storage Platform | 70-03-01-XX/XX or later |
| Unified Storage VM | 73-01-07-XX/XX or later |
(1) Support only for VSP N block controllers
Make sure REST API is installed and configured properly for your VSP storage systems before enabling it in STOR2RRD.
Check
Hitachi docu ➡ Get started
CCI still has to be used for older models where REST API is not available.
Exclusions
- REST API does not support GAD statistics, it would require admin storage rights
- Older firmware levels do not support FMC capacity statistics
Known issues
- G400 have an issue on 83-05-39, it works fine with 83-05-40